11/12/2021
FAQs
PREPARATION
Q: How do I prevent my spray can tip from clogging?
A: Prevent blocking by turning the can upside down and spraying until clear gas emerges. Also wipe front of nozzle clean. Clean up over spray while it is still wet with mineral turps.
Q: How do I prevent spray paint overspray?
A: Overspray can occur both indoors and outdoors. Depending on your project and location of your spray paint area, there are multiple materials that can be used to cover surrounding surfaces and protect them from overspray, including:
Newspapers
Painter’s Tape
Drop Cloths
APPLICATION
Q: How to use a WRX Spray Can?
A: Ensure application surface to be painted is clean, and fully freed from grease, dust, loose particles / paint layer, rust and humidity. The can is ready to apply. Release the security trigger on cover, shake it well (for at least by 1-2 minutes after you heard the agitator ball has started to rattle inside) and push in short blasts to apply with constant finger pressure on its dispersion valve from 25-30 cm distance from surface and apply it with an even dispersion rate in double cross consecutive light coats (shake occasionally during the use and allow 3-5 minutes between two coats). When the application is finished, if still remainder paint in the bottle, return the bottle upside down and press on its dispersion valve until it loosens in order to be able to re-use it at another time.
Q: What should I do before painting?
A: Read the directions on each aerosol can. WRX Spray products outline instructions to ensure optimum results. Generally, you should prepare the surface by removing dirt, grease, rust, wax, moisture and loose paint. Make sure the surface is clean, dry and free of contaminants.
Q: How do I apply spray paint evenly?
A: Shake your WRX spray can vigorously for two minutes after the ball within the can begins to rattle. Test your spray paint and painting technique on a piece of scrap material until you have achieved a satisfactory result. To ensure surface compatibility, test spray on an inconspicuous area before continuing with the whole project. (Some surfaces may need pre-treatment or be unsuitable for painting) Hold can upright 10 to 25cm from the surface. Begin and finish your spraying off the object, releasing the tip at the end of each pass
Q: Who can use spray paint?
A: Spray painting is fun, and a little practice will enable any amateur to obtain professional results. Just read the directions carefully, always spray lightly and practice spraying on an old carton or box.
Q: Why do I have to shake well?
A: High quality ingredients and very high pigmentation levels guarantee good coverage. Shaking the can well ensures that the pigments and other ingredients mix well for a perfect job.
Q: How long does WRX Spray Paint take to dry?
A: Touch-free in 5-20 min. Full dry in 8-12 hours. Resistance to abrasions and chemicals in 24 hours.
